Microgrid fundamentals
Microgrid fundamentals
Microgrid fundamentals

Microgrid fundamentals

VGRID POWER microgrid fundamentals and selection guides: system architecture, power classes, grid-tied/off-grid transfer and typical applications.

Technical articles

Three paradigm shifts in microgrid inverters: off-grid, seamless transfer and always grid-forming

The VGRID POWER technical library divides microgrid inverter evolution into three stages: a simple off-grid inverter, a dual-mode inverter with seamless on/off-grid transfer, and a grid-forming inverter that always behaves as a voltage source. This is not merely a reduction of transfer time from hundreds of milliseconds to 10 ms; the dividing line is whether the control structure changes abruptly. In always grid-forming operation, grid-connected and islanded are only connection states, not operating modes.

What counts as genuine grid-forming: four verifiable criteria

Being able to run in island mode does not make an inverter grid-forming. The VGRID POWER technical library gives four criteria: permanent voltage-source behaviour, virtual inertia and damping, communication-free paralleling, and flexible interconnection of microgrids. Each can be turned into a tender clause and a site test, preventing a dual-mode inverter from being purchased as a grid-forming unit.

From SSG to VSG and Synchronverter: twenty years of grid-forming control

Grid-forming is not a recent feature but twenty years of accumulated research and field work: the IEEE task force proposed the Static Synchronous Generator in 1997, VISMA and VSYNC defined the VSG almost simultaneously in 2007, the Synchronverter embedded a full synchronous-machine model in 2008-2009, companies such as SMA brought it into real microgrids after 2010, and State Grid listed virtual synchronous machines among its ten key innovation programmes in 2016.

Where virtual inertia and damping come from: understanding VSG through the swing equation

VSG is not a deliberately sluggish ramp added to an inverter; it is a synchronous generator simulated inside a digital controller. Virtual inertia corresponds to rotor inertia, virtual damping to damper windings, active power-frequency droop to the governor and reactive power-voltage droop to the excitation regulator. Once that mapping is clear, frequency rate-of-change and recovery time under a load step become readable.

Three open problems for grid-forming microgrids: LVRT, short-circuit capacity and weak-grid SCR

As grid-forming inverters move from microgrids into utility networks the demands rise sharply: voltage-source behaviour conflicts with low-voltage ride-through, power semiconductors limit fault current to 1.1-1.5 times rating (2-3 times in special designs) against 5-10 times for a synchronous machine, and falling short-circuit ratio raises multi-unit interaction and optimal penetration questions. The technical library lists these as the next barriers to break.

Demand Charge Management with BESS Control

For demand charge management, the answer-first conclusion from VGRID POWER is to fix the continuous load profile, the short-time overload factor and the grid strength before choosing a grid-forming

Oilfield DC Bus and Pump-Jack Group Control

For oilfield DC bus microgrid, the answer-first conclusion from VGRID POWER is to fix the continuous load profile, the short-time overload factor and the grid strength before choosing a grid-forming