Grid-tied/off-grid / weak grid microgrid
Grid-tied/off-grid / weak grid microgrid
Grid-tied/off-grid / weak grid microgrid

Grid-tied/off-grid / weak grid microgrid

On/off-grid · Weak grid · Grid-forming

On/Off-Grid and Weak-Grid Microgrids: Stable Power Where the Grid Is Not

Weak grids lack a stiff voltage and frequency reference, so grid-following equipment trips repeatedly, while long feeders suffer voltage violations and three-phase imbalance. VGRID POWER uses VSG grid-forming PCS to establish voltage and frequency, combined with millisecond STS/PCM transfer and EMS dispatch for grid-connected operation, seamless islanding and black-start recovery.

Key Points

  • Grid-forming differs from grid-following in providing the voltage/frequency reference, not in efficiency; weak grids and islands need at least one grid-forming unit.
  • STS/PCM handles on/off-grid transfer, typically under 20 ms; critical loads still require UPS ride-through and load-shedding checks.
  • Earthing must be revisited in island mode: without the utility earth reference, PCS neutral point, transformer and protection settings need a coordinated design.
  • Multi-unit paralleling uses VSG droop and communication-free current sharing; align firmware, droop coefficients and DC voltage windows before load commissioning.

Selection & Implementation

A practical sequence is load classification, short-circuit and earthing review, grid-forming capacity sizing, transfer and protection settings, then black-start and load commissioning. VGRID POWER supplies 30 kW–12.5 MW grid-forming PCS, STS/PCM modules, AC microgrid cabinets and EMS, with EN 50549, TUV and AS/NZS 4777.2 documentation.

Frequently Asked Questions

Can off-grid capability be added later?

It depends on whether the installed equipment supports grid-forming operation. Standard grid-tied PCS units cannot establish voltage and frequency on their own; adding an STS/PCM module on the AC bus and a grid-forming PCS is usually required. Reserving the interface at design stage is recommended.

What matters when paralleling multiple units?

Align firmware versions, droop and current-sharing parameters, DC voltage windows and protection settings, then commission under load. Above single-unit capacity, use N+1 redundancy and recheck short-circuit capacity and cable ampacity.

What information is needed for an accurate proposal?

Provide a load schedule with 15-minute load data, daily energy use, required autonomy days, PV and diesel capacity, battery chemistry, local grid code and ingress-protection requirements. We return a single-line diagram, bill of materials and acceptance test plan.

Related Equipment & Resources

Related equipment: grid-forming PCS, static transfer switches, hybrid inverters and EMS. PCS · Hybrid PCS · FAQ

Contact our engineers — Need a design, selection sheet or quotation? Contact the VGRID POWER engineering team.